44969 Exposure Head Interface EHI: crash detected, error code = 0x<Error code> Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The firmware in the Head Controller has crashed. Just before the firmware crashes (and resets itself), the error is written to NVS. After the firmware has recovered, it reports this error code to the MPE. Usually, the error code will explain the reason for the fault. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Numerous reasons: datalink problems, Head Controller firmware problems, etc. Error code The error code that caused the head firmware crash. 03-Jul-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:42 2008 PST